．Rapid Hardening: Initial setting occurs in approximately 2.5 minutes, and final setting occurs in approximately 4 minutes. If necessary, hot water can be added to expedite the setting process.

．Improved Early Strength: The product has a compressive strength of approximately 350 PSI after 1 hour and can reach around 1,500 PSI after 24 hours.

．No Reinforcement Corrosion: This product does not contain chlorides, so it does not cause rust or expansion of reinforcement bars.

．Non-shrinkage: The inclusion of inorganic expansive materials prevents any gaps from forming after the setting process.

．Strong Adhesion: The product contains non-EVA adhesive, which contributes to excellent adhesion properties and eliminates water hydrolysis.

．Excellent Water Resistance: According to CNS10639 testing, the product has a water absorption rate of less than 10g and a water permeability ratio of below 5%.

．Chemical Resistance: The product can resist most chemicals with a pH range of 3 to 12.

．Saltwater Resistance: The product can solidify and maintain its shape in water, and it is not susceptible to erosion by saltwater.

[Pre-treatment]

Open the leaking or water flowing area to form a "U-shaped groove" (not recommended "V-shaped groove").

Remove any foreign objects and loose materials.

[Mixing]

Mix a certain amount of water with the powder to form a non-flowing paste. Apply pressure with your hand to the source of the water and allow it to sit for 1 minute to stop the flow.

When mixing, it is recommended for the operators to wear rubber gloves. In case of splashes to the eyes, immediately rinse with plenty of water and seek medical attention.

After opening the product, please use it as soon as possible. Prolonged exposure to high-humidity air can affect its effectiveness.

Storage: Sealed properly, it can be stored for up to 6 months.